§ 17.20.110. Preparation—General configuration.
The parcel map shall be prepared by, or under the direction of, a registered civil engineer or licensed land surveyor and shall conform to the requirements of the Subdivision Map Act and to the following:
(1)
General form and layout of the map, including size and type of lettering, drafting and location of acknowledgements, etc., shall be as determined by the city engineer.
(2)
The scale of the map shall be one inch equals 50 feet, unless otherwise permitted by the city engineer, but in any case the map shall show clearly all details of the subdivision.
(3)
All dimensions shall be shown in feet and hundredths of a foot. No ditto marks shall be used.
(4)
If more than three sheets are necessary to show the entire subdivision, an index map shall be included on one of the sheets.
(5)
Parcel map number, scale and north point shall be shown on each sheet.
(6)
A title sheet, designated as page number one of the parcel map, shall be provided; except, that where the size of the subdivision permits, the information required to be shown thereon may be shown on the same sheet as the map of the subdivision.
(7)
The parcel map shall be so made and shall be in such condition when filed that legible prints and negatives can be made therefrom.
(Ord. 324B §4-8, 1977)